The ROBOSLIT ® RL (Rear Loading) dual turret slitter rewinder is a compact, rear loading machine with a dual turret rewind section that permits changeovers within 26 seconds, resulting in significantly higher outputs as compared to its duplex counterpart.

ROBOSLIT RL - Dual Turret Slitter Rewinder Rear Loading
ROBOSLIT RL - Dual Turret Slitter Rewinder Rear Loading

Technical Specification

Position , type of unwind Rear, integral
Maximum web width 1300 mm (upto 1650 mm on request)
Maximum unwind diameter 1000 mm
Unwind core inner diameter 76 mm and 152 mm
Maximum rewind diameter 600 mm
Rewind core inner diameter 76 mm
Minimum slit width 50 mm (30 mm on request)
Layon displacement Horizontal
Layon actuator Pneumatic piston
Rewind splicing Automatic
Tension management Automatic, intelligent (ITM™)
Job setup Manual
Turret structure Cantilevered
Static management Static elimination
Maximum machine speed 800 m/min
Rewind change-over time 26 Seconds
Materials handled Plastic films, flexible packaging laminates

Optional Features

Shear cutting mode – tangential, for paper and aluminum foil based laminates
Electro-mechanical, linear floor lift for unwind reel
Motorized ejector for displacing the rewind reels on to the off loader
Auto off loader to bring the ejected reels to waist level for easier removal
Trim winding unit for the compact accumulation of trim waste
Rewinding on 152 mm/ 70 mm ID rewind cores
Additional safety devices
CCTV
SCADA

Related Products

ROBOSLIT FSU turret Front-  coil cantilevered slitter rewinder Rear
Good overall visibility
26 seconds changeover
800 m/min
ROBOSLIT ® FSU
ROBOSLI OHP Front-Turret slitter rewinder machine Rear
Hygienic environment
26 seconds changeover
800 m/min
ROBOSLIT ® OHP
Roboslit Plus Front-Turret slitter rewinder machine Rear
Servo driven lay-ons
Supported rewind turrets
1000 m/min
ROBOSLIT ® plus OHP